| |
| Home > Products > Sensors, Transmitters and Controllers > Flow > Transmitter |
|
|
| |
Transmitter |
|
| |
|
|
| |
Type SE10 - Transmitter for INLINE sensor-fitting |
|
| |
| |
|
|
| |
The type SE10 is not available anymore since 1/1/23. |
|
| |
If you have any questions, please contact us. |
|
|
|
|
| |
|
|
 |
| |
| |
Type Description |
|
| |
The 8010 INLINE flow switch is used to monitor pure, water like liquids, and the monitored liquid must not contain magnetizable particles. The switch consists of a connector (S010) and an electronic device module (SE10), which can be quickly and easily connected through a bayonet connector. The device displays the presence of flow through the reed switch included in the electronic device module. The "minimum/maximum" switch point can be adjusted within a specific range by using an adjustment bolt located on the electronic device module for increasing and decreasing flow rates. There are two types of SE10 electronic device modules available: - No flow open (NO): Flow will close the contacts- No flow closure (NC): Flow will open the contacts. The S010 connector has different interfaces and two structural options available: - With a small impeller, Zone 1 is suitable for connectors DN15 to 40- Equipped with a large impeller suitable for joint DN32 to 50 in Zone 2. |
|
| |
|
|
| |
Features |
|
| |
« Low cost integration into pipeline systems without the need for additional piping |
|
| |
« Principles of Magnetic Measurement |
|
| |
« Easily set switch points by adjusting bolts |
|
| |
|
|
|
|
|
|
|
|
| |
|
|
|
| |
|
|
|
|
中文
蘇公網(wǎng)安備32050502000264號(hào)